Please Help Me! B100P Configuration in Trixbox 2.6.1

hello,
you have to under zaphfc dir, then run that command.
regards!
James.zhu

Hi, I did that you told me, however, it presents same fail.

I am under the ZAPHFC directory.

Somebody more have one idea?

DIDIER

hello,
please email your ssh account to This email address is being protected from spambots. You need JavaScript enabled to view it., i will check it for you.
regards!
james.zhu

Ok, I'll put my SSH account and will give you the data. Today I'm not at the office, however tomorrow I'll go and I'll do the configuration, then I'll write you.

Thanks for you collaboration.

DIDIER

Hi, thanks for your help!

My two B100P OpenVox cards were installed under mISDN Driver, still I would like to install them with Bristuff driver, however, I want to know why back LED's don't function? My Cards are unplugged, but I think that it LED's must be "ON" in red or green and blinking.

Can somebody tell me of this about?

Another question: Where can I to find mISDN documentation, about of the general commands?

Thanks

DIDIER GRISALES MONTOYA

hello,
the B100P does not support LEDs, even the leds are there. unless you install isdn4bsd in freebsd, the leds will work.
you can go to :www.misdn.org to see more docs.
regards!
James.zhu